 |
LavryBlue-MicPre |
|
有三種Mic模式可以切換，電容Condenser, 動圈Dynamic, and 絲帶Ribbon Settings all on one |
|
module. |
|
Module for easy installation into LavryBlue Chassis |
|
數位精準的增益設定+可記憶的儲存Digital Precision Gain Setting + Stored Memory |
|
1dB單位增減，最大可達70dB
21-70dB Gain in 1dB Steps |
乾淨、通透的HiEnd表現
Designed for clean, transparent high end performance at $968 USD, the stereo modules fit in a LavryBlue chassis which can accommodate 2 or 4 channels of mic pre’s. The typical 2X2 configuration (2A2D) can be expanded to include 2MicPre. If you already own a LavryBlue chassis this module takes 2 spaces. Plug and Play with the installation kit.
超低雜訊+超大增益
The MicPre provides state of the art noise performance that accommodates even the weakest microphone signals , and a wide input range for the strongest mic signals. Ultra-low distortions across the complete audio frequency band insure maximum signal transparency at all gain settings.
傑出動態，乾淨通透的低頻變壓輸出
The unit is designed to yield a superior dynamic range even for high source resistance microphones. The transformer free input provides pure and transparent bass, yet it features state of the art in common mode rejection (for elimination of hum and interference pickup) exceeding transformer based units. Phantom power per channel is ultra- low noise double shunt regulated for minimum noise and channel separation.
Each channel accommodates up to 21-70dB of gain in 1dB steps. The precision gain setting is solid and reliable (not based on the use of archaic rotary switch technology). Included is a 10dB pad for lower voltage analog interfaces. Activating the pad yields 11-60dB gain.
數位控制，自動記憶
Outside, the no-nonsense controls are extremely user-friendly. Each channel is equipped with a 2-digit gain setting display and up/down switch. The last gain settings are stored and will reappear at next use. A Gain Pad switch (per stereo pair) changes the gain range from 21-70dB to 11-60dB, for higher level inputs.
三種Mic模式，增加使用變化
Each stereo pair has a microphone selection switch (Condenser, Dynamic or Ribbon), for microphone load optimization. Setting to “condenser” activates the phantom power. Internal jumpers allow change from balanced to unbalanced outputs, and for disabling of the phantom for powered vintage mics.
點選右鍵觀察詳細的電路測試結果報告 CLICK HERE
| 
