1 - CueMix DSP mixer controls Create up to four stereo monitor mixes with 20 inputs each using these front-panel controls. Mix to any four output pairs you wish. Because the mixing takes place in the 828mkII itself, your computer’s processor is free for other tasks.
2 - Volume control Dual function knob provides separate volume control over main outputs and headphones.
3 - Front-panel mic/guitar inputs Two front-panel inputs accept either high impedance quarter-inch inputs or low impedance XLR microphone inputs. The microphone preamplifers provide plenty of gain and individually switchable phantom power. Use the rear-panel sends to insert an outboard EQ, compressor, reverb or other processor before the signal goes digital.
|
4 - S/PDIF I/O Stereo 24-bit, 96kHz S/PDIF digital I/O. Connect a DAT machine or effects processor.
5 - ADAT sync port Provides sample-accurate sync for compatible devices. Transfer multiple passes of ADAT via lightpipe with single-sample accuracy every time.
6 - ADAT optical I/O Eight channels of ADAT optical (lightpipe) input and output. Connect a digital mixer, ADAT or additional A/D/A converter. Also supports four channels of 88.2 or 96kHz audio. |
7 - International power supply Built-in international power supply accepts 110-220v on a standard IEC cable so your 828mkII can follow you wherever your music takes you.
8 - Word clock Word clock input and output for synchronization with a wide variety of digital devices — or a centralized word clock source.
9 - Standard 1394 ‘FireWire’ ports Connect your FireWire-equipped computer here. No PCI or PC cards to install — just plug in and go. MOTU FireWire interfaces are expandable; the second FireWire port allows you to daisy-chain more devices without the need for a FireWire hub.
|
10 - Backlit LCD display The 828mkII can be used as a stand-alone mixer. The front-panel display allows you to configure your system using an intuitive interface. Every setting is available from the LCD.
11 - Level meters / status indicators Dedicated LEDs display audio levels, tach and lock status, and clock rate.
12 - MIDI input and output No need to carry an additional MIDI interface. Connect a MIDI controller, keyboard, sound module, control surface or any other MIDI device.
13 - Eight balanced TRS analog ins/outs 24-bit 96kHz analog inputs and outputs on balanced/unbalanced quarter-inch connectors. Input level can be switched between +4/-10 for each input via software.
|
14 - Sends These pre-amplified analog outputs from the two front-panel inputs allow you to insert a compressor or effects processor before the signal goes digital. Use any input as a return.
15 - Main outputs Connect powered monitors directly to these jacks and separately control your main mix and monitor levels with convenient, front-panel knobs.
16 - Hands-free punch in/out Connect a pedal for hands-free punch in and out.
17 - SMPTE I/O Resolve the 828mkII directly to an external analog tape deck or video source. No extra synchronizer needed. |